Motor Driver For Nema 2M423A

2M432ACharacteristic :1.Using new  digital sinusoidal micro-segmentation algorithm 2.Lower  heating and noise ,Website:http://www.wotomotors.com, higher stability 3.The phase  current can be adjusted by switch DIP.4.For the  input control signal, electric circuit use optically coupled isolator to low  the noise interference .5.With short  circuit, overvoltage, undervoltage, overtemperature protection and improving  functionsstepper Motor driver Specification :Input    Power supply :12-40VDCOutput    Current0.4A～3.2ADrive    WayPWM constant    current chopping ,two phase Sine wave output currentSuitable    stepper motor35,42,57    series two phase stepper motorAmbient    environment-10℃～55℃    15～85%RH、No condensation. Non-corrosive, flammable, explosive,    conductive gas, liquid and dustKeeping    enviroment－40℃～ 55℃, ＜93%RH,No condensation, no frostSize    (L*W*H)115*68*24mmNet Weight0.25 KgCurent seting :SW1-SW3000001010011100101110111Phase current0.4A0.8A1.2A1.6A2.0A2.4A2.8A3.2AMicrostep Subdivision setting :     SW1-SW3000001010011100101110111steps/rev28101620324064Describtion :Microstep    setting    Users can set the driver Microstep by the    SW1-SW5 five switches,total 28 micro-step. When you set the    microstep , pls stop the driver working.The    setting of the specific Microstep subdivision, please refer to the    instructions of the driver panel figure .Output    current setting  Users can set the driver Microstep by the    SW1-SW5 five switches. The setting of the specific Microstep subdivision,    please refer to the instructions of the driver panel figure..Double    pulse setting    SW7 sets pulse mode, setting
Motor Driver For Nema 2M423A